Draytek Vigor 2130 Guia do Utilizador descarregar pdf (Página 202)

Vigor2130 Series User’s Guide

194

Destination Subnet Type the subnet mask here if you choose Subnet as

Destination IP Type.

Source Start Port Type a value as the source start port. Such value will be

available only TCP/UDP is selected as the protocol.

Source End Port (optional) Type a value as the source end port. Such value will be

available only TCP/UDP is selected as the protocol.

Destination Start Port Type a value as the destination start port. Such value will

be available only TCP/UDP is selected as the protocol.

Destination End Port (optional) Type a value as the destination end port. Such value will be

available only TCP/UDP is selected as the protocol.

Action Set the action that the router will perform for the packets

through the protocol of IPv6.

Accept – If the IPv6 packets fit the condition listed in this

page, the router will let it pass through.

Drop - If the IPv6 packets fit the condition listed in this

page, the router will block it.

Refer to the following example.

1. Use TSPC mode to connect to IPv6 network.

PC get ipv6 IP: 2001:5c0:1503:7400:30e4:139d:53c8:3a1e

2. Connect PC to http://www.ipv6.org/

with IPv6 IP address.

A message will appear from the web page:

Welcome to the IPv6 Information Page!

You are using IPv6 from 2001:5c0:1503:7400:30e4:139d:53c8:3a1e

3. Set firewall rule to block all TCP traffic from this IP address.

4. Open IPv6 >> IPv6 Firewall Setup and press Add New Rule.

In the following dialog, please configure the page with the following values.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 240 241

Sem comentários

Draytek Vigor 2130 Guia do Utilizador Página 202